There are all router commands available.
Entering the enable command will take you to global configuration mode.
The “>” symbol appears at the end of the device prompt for this mode.
It is possible to configure interfaces and routing protocols.
Only a portion of the router setup is visible.
The correct answer is these two:
Only a portion of the router setup is visible.
The “>” symbol appears at the end of the device prompt for this mode.
Explanation: In User EXEC mode, you can’t use some show and debug commands. When configuring a router, this is the initial level of user interface you’ll see. It’s for examining the device’s functions. The User EXEC prompt is indicated by the “>” mark.